CFP Standard 2 Zone Conventional Fire Alarm Panel

Approvals / Certifications	Certified to EN54-2 & 4 by the LPCB, Certified to EN54-13 by Kiwa Telefication
Mains Supply	230V 50/60Hz
Mains Rated Current	350mA maximum
Internal Power Supply	19V–28.5V (27V nominal). Ripple 7V maximum (battery fault)
Total Output Current Limited To	1.5A @ 230Vac (ImaxA eq 146mA)
Quiescent Current	25mA (mains failed, internal sounder active, PSU & gen fault LED lit)
Max Battery Size and Type	2 × 12V 3.2Ah VRLA connected in series. Min. battery size 1.2Ah
No. of Detector Zone Circuits	2 (Max. length per circuit is 500m)
Call Point Resistor Value	470 to 680Ω
Max Devices per Detector Zone	25 detectors (or 32 detectors/manual call points combined)
No. of Conventional Sounder Circuits	4 (Max. length per circuit is 500m)
EOL Resistor Value	6800Ω 5% Tol. 0/25W (blue, grey, red, gold)
Alarm Voltage	27V max, 20V min (final battery voltage)
Max Sounder Output Current	4 × 200mA (800mA total)
Auxiliary Relays	Two: (1) Aux. Fire; (2) Fault. Volt free single pole changeover. Max. switch current 1A; Max. switch voltage 30Vdc
Open Collector Outputs	Two: (1) Reset; (2) Remote. Max. sink current 30mA
Other Outputs	24V Aux. Power (protected by resettable fuse, 100mA min. hold current)
Auxiliary Inputs	Two: Class Change & Alert. Connect to 0V to trigger, max input 27V
Engineer (AL3) Functions	Coincidence, Walk Test, Delays, Non-latching zones, Sounder resound
Expansion Connections	Optional network driver cards, relay output cards, EN54-13 boards
Product Dimensions (mm)	380 W × 235 H × 96 D (Flush cut-out: 367 × 220 × 75)
Construction & Finish	Plastic lid and base; RAL7035 textured
IP Rating	IP30
Weight	1.75kg (without batteries)
Operating Conditions / Temperature	-5°C to +40°C, Max relative humidity 95%

Third-party certified to EN54 parts 2 and 4 by the Loss Prevention Certification Board (LPCB) and EN54 part 13 certified by Kiwa Telefication.
Intuitive user-friendly interface with colour-coded buttons and combined keypad/keyswitch entry.
Manufactured by C-TEC in the UK.
Two detector zone circuits.
Four conventional sounder circuits*
Integral 1.5A EN54-4/A2 compliant switch mode PSU.
Wide range of engineering functions including zone test, coincidence, zone delay and non-latching zones.
Two on-board relays (Fire and Fault).
Two open-collector outputs (Remote and Reset).
‘Class change’ and alert inputs.
Installer-friendly design.
Attractive flush or surface mountable plastic lid and enclosure – no bezel required.
Low 25mA quiescent current.
Multiple indicators.
System expansion connections provided for up to eight two-wire repeaters (one CFP761 network card required per system) and optional CFP relay boards.
Space for two x 12V 3.3Ah VRLA batteries.
Fully compatible with C-TEC’s ActiV fire detectors, sounders and visual alarm devices.